Quoted By:
Step 1: Filter the vinegar through a cotton ball placed in the stem of a funnel into a pot. Then pour about a shotglass of water through the cotton ball into the pot to wash out any remaining vinegar.
Step 2: Boil the vinegar down on max until it is around 40-50ml
Step 3: Remove the pot from heat, then use a dropper to carefully filter the liquid through a cotton ball back into the pot then wash the vinegar out of the cotton ball again with water.
Step 4: Lower the heat to medium low and watch it carefully until it is around starts to become red in color.
Note 2: You can estimate the resulting liquid based on the amount of MHRB used. The combined vinegar from 3 solvent pulls will result in roughly 1tsp/5ml for every 100g MHRB used at 10mg/drop. Generally it's much less liquid than you expect, especially if you're used to dosing with crystals.
Step 5: As the liquid becomes redder and redder, before the liquid is all gone, remove the pot from heat, tip the pot to the side and use a dropper to transfer your tincture to a dropper bottle.
It is a delicate balance of not removing all liquid, but getting a good concentration. It is best to aim for a little less liquid than a little more for 2 reasons:
You’ll need to rinse the pot with a few mL of water to get all the DMT off, adding additional liquid to the tincture
Adding more liquid is extremely simple, while removing liquid means doing the condensing again.
