>>1551154> bought shimano tourney 6 gearnew or second hand ?
>And the sixth is just skipping all the timeunder load ?
or during constant low effort pedaling ?
the sixth gear or smallest cog is often worn out due to having only 14 or 13 teeth
a common wear pattern due to user error is to sharktooth
.eg the wear on the sprocket will not be symmetrical but will bend clockwise towards the forward rotation of the chain
>Would that be fixed if I just tighten up the cableno if the skipping is from the derailleur trying to down shift past 6th gear either the lower limit screw is too loose or the derailleur is bent
if the derailleur is trying to shift upwards tightening the cable will force the chain to shift to 5th
after this up shift you can then loosen the cable to the point that it shifts down again
at the point it shifts down it is unlikely that it will attempt to jump up again
but if it does you can just loosen it a little more
note that indexed shifting causes many problems further up the cassette
https://www.youtube.com/watch?v=UkZxPIZ1ngY&t=0s&index=4&list=PLVei2goGgwxs0ouFrFjjyuVG102rOC1YmI tend to set the limit screws at first by disconnecting the cable and moving the Derailleur to the largest and smallest cog by hand, that sets the limit for how worn out and wobbly the pivots are
