>>6304102/?
Chain Sinnet Bracelet
Vid:
https://www.youtube.com/watch?v=4uDhsnYYI7sTakes longer to make than the bracelet you've got now, but so much easier to get to your cordage when you need it.
Steps:
>Find the middle of a 10-12 ft. section of Paracord and halve it>Take the middle and girth hitch it into the female portion of the buckle>Thread the two working ends through the bottom bar of the male portion of the buckle>Now place what you’ve created around your wrist and tighten the working ends until you have the desired size>*You’ll want it snug, but not tight, as the pattern we’ll be creating will add some girth to the bracelet>Take the right side working end and create a bight (loop) and bring it over the standing center part>Take the left side working end, create a bight and loop it through the loop you just made with the right side working end>Ensure the new bight passes through your initial bight from the top, not the bottom>Pull on the standing right hand strand to tighten the loop that’s now holding your second bight>Take this secondary left side working end bight and take it under the standing center part>Repeating the same type of work you just did, you’re now going to create a new bight with the standing right side line>This bight now passes through the bottom, rather than the top as you just did with the last side>Now you’re just repeating those steps, alternating from the right side going over the standing part and the left side going around the back of the standing part>Remember to tighten and push the “knots” down as you go>As you pull through your last bight near the male buckle, you’ll actually pull this side all the way through and into the female buckle>The opposite strand you’re left with will be also threaded into the male buckle>Now that both strands are out the backside of the male buckle tuck them behind the topmost loop of the solomon bar wrapping>Tighten and trim to desired length 