I printed some of the Max figurine models from this guy's
>>10212875 page and like I suspected and the other anon above did too, they just aren't great models. Not bad, but not great either. There are a lot of things the sculptor should have done since these are getting printed so small:
-Get rid of the gap in between the legs or make it wider since the minimal gap they have just gets resin gunked up in there
-Sharpen all the details because everything just look soft. And it's not the prints. The render of the models look soft even, as another anon pointed out too
-Make the scored lines on the hat deeper and the recessed eyes/mouth slit deeper since they are just too damn subtle to show up well.
-Thicken the feet and probably enlarge them a bit too so it has an easier time standing.
The first four prints are from that above mentioned artist, Black Fox, and the one on the far right is from another artist, shown in below post. That model is better than the others with sharper details that show up when printed at scale. You can even see his pupils, individual hair strand details, and the details on the clothing is better. My biggest gripe with that one was that the feet were not flat on the bottom and only a super thin ridge around the perimeter of the shoes was what he stands on, so those got all warped when printing.
