[10 / 6 / 1]
Quoted By:
Hi, total pcb newb here, but maybe some good soul might help.
Can i make any ad hoc changes in order for this little guy to only go full speed strob / off? It's a small circuit board for a stroboscope light with several speed settings - and that's the problem.
its current modes are (in order of subsequent clicks) : 25% strobe, 50%, 75%, 100%, and off.
No knowledge on circuits here, i just need this to work 100 - 0, (with no additional modes in between) for a cyberjacket project. If it's as easy as applying some tin i'd be thrilled. if not - thanks in advance for any reply.
Can i make any ad hoc changes in order for this little guy to only go full speed strob / off? It's a small circuit board for a stroboscope light with several speed settings - and that's the problem.
its current modes are (in order of subsequent clicks) : 25% strobe, 50%, 75%, 100%, and off.
No knowledge on circuits here, i just need this to work 100 - 0, (with no additional modes in between) for a cyberjacket project. If it's as easy as applying some tin i'd be thrilled. if not - thanks in advance for any reply.
